Cradle for Garmin GPSMAP 76C, 76CS, 96, 96C
Works great with the RAM-A-101 mount extension below.
Note: The Garmin GPS 72, GPS 76, GPSMAP 76 and GPSMAP 76S will not fit this cradle. These units require the RAM-HOL-GA6U cradle.

Customer Feedback
"The RAM-HOL-GA14 fits the GPS-96C just fine, and two of the three ports on the back are available when the GPS is in the mount (the antenna port and the USB port).  However, the serial port (the round Garmin plug) is covered by the mount.  To access it without repeatedly flexing the mount to remove and reinstall the GPS, one would have to cut a section out of the back between the lower two mounting holes, right where it says 76C/76CS on the inside face of the mount.  Due to the odd orientation of the plug, the cutaway must be flared to the left as you look at the back of the mount to accommodate the cable which goes down and to the left as you look at the back of the GPS."
However, The owner of RAM sent me a response to the statement above, "I have a GA14 on my boat with the serial cable and it works fine."  
They must be using different serial cables...

Write a review

Note: HTML is not translated!
    Bad           Good

RAM-HOL-GA14U

  • Brand: RAM
  • Product Code: RAM-HOL-GA14U
  • Availability: In Stock
  • $10.95


Related Products

RAM-HOL-GA6U

RAM-HOL-GA6U

Cradle for Garmin 72, 76, GPSMAP 76 and GPSMAP 76S Handheld GPSsPlastic cradle for Garmin 72, 7..

$10.95

RAM-A-101U

RAM-A-101U

Articulated Arm, Short, "A" SizeArticulated Aluminum Arm, Length: 3 1/8 inches (80 mm) fro..

$32.00

Tags: